How do you root a plant?
Question:I would like to take a clip from a climbing rose and root it so I can plant it in another area. Does anyone know how this is done?
Answers:
Get a few good clippings from an end of rose branch at least 6 inches long(cut at an angle). Dip end in rooting hormone powder (bought at most garden centers or Wal-Mart). Dig your hole , place cutting in it, add some organic material...leaves, coffee grounds, peat moss, etc., fill with dirt and water (some fertilizer won't hurt either) well. Get a gallon size glass jar (pickle jar works good) and place over cutting. Keep watered and occasionally fertilize. Leave jar over start until you see new growth forming and cutting growing...it may look sick at first...give it time. If the weather turns colder before this happens, leave jar on all winter. Place a red brick on top to make sure that glass jar doesn't tip over. You want to keep cold air off of your rose start. It works like a mini-hothouse. Climbing roses are usually easier to root from cuttings than Hybrid...they usually have to be grafted.
http://aggie-horticulture.tamu.edu/south...
http://www.gardenguides.com/how-to/tipst...
http://www.gardenersnet.com/roses/roses0...
The easiest way is go to and gardening center and get Root Start. I don't know who makes it but I've heard it works very well. Just follow instructions. Good Luck!
***You can buy a product at any store that sells garden equipment (OSH, Wal-Mart, Home Depot, Lowe's, etc.) that is specifically for root growth. ***
You can also keep it in fresh water and it might grow roots on its own.
Roses aren't the easiest thing to root but it can be done. The method that worked for me in the past is as follows:
You will need: rooting hormone, 2 liter soda bottle, a large nail, pliers, sissors, potting soil, small cup of water, rose cutting.
Be sure to carefully read the directions on the rooting hormone and follow those directions if the differ from the general ones I give bellow.
1. Pick up a container of rooting hormones for your local nursery. Some big stores or hardware stores may carry it. I think the brand I have is Root Zone, but they all work the same. You could try to root without the hormone, but it will take much longer and might not work at all.
2. Get a 2 liter soda bottle and rinse it clean. Put the cap back on the top.
3. Use a hot nail to poke/melt holes in the bottom for drainage. I hold the nail with some needle nose pliers and heat it with my gas range. If you have an electric range, a candle works just fine. Make at least 6 holes.
4. At about 1/3 of the way from the bottom, start cutting around the cylinder of the bottle. Don't cut all the way around, leave about 2 inches connected.
5. Bend the top back and fill the bottom with potting soil. You can use regular potting soil or a seed starter mix. Moisten soil.
6. Poke a hole in the middle of the soil for you cutting.
7. Get your rose cutting. If it was cut from the plant earlier, you'll want to make a fresh cut. The cutting should have at least 3 growth buds and no flowers. Remove flowers if there are any.
8. Dip cutting in water, then in the rooting hormone. Gently tap off any extra.
9. Put cutting in hole and gently fill in the hole. Try to keep as much of the hormone powder on the stem as possible.
10. Bend the top of the bottle back into place, and secure with a small piece of tape if it's too loose.
11. Watch and wait. Water periodically. It should take a couple weeks at least, but the rooting hormone may give a specific time.
Please be aware that you new rose plant may not thrive in the same conditions as parent plant. Most commercially sold roses are grafted onto root stock that is hardier and has a stronger root system then the hybrid rose.
Good Luck!
Cut off a piece of new growth. Take off all but a few leaves. Stick it in root-tone or other root stimulant. With a stick make a hole in potting soil to stick the root into. Water well. Keep in a shady spot. Keep watered. When root growth is seen. usually about 4-6 weeks plant in soil
More Related Questions & Answers...