What is a chop saw ?
Question:
Answers:
chop saws are deceptive looking tools. You will need to take care when you are using these types of saws.
You will find many different brands of chop saws on the market that you can buy. Each of these many different saws has been made by different manufactures. They have the power that is needed of cutting through different items. The lightweight circular saw arm can cut the wood that is placed on the base of the saw.
This saw is also called a circular saw due to the circular shaped blade. The blade is located in a sturdy sheathe. To lower the saw to cut your project piece you will need to lower or raise the spring loaded pivoting arm. Once the blade saw arm has been lowered onto the work piece the machine powered motor will cause the saw blade to cut the wood. You can control where the saw makes it cut marks by preparing the work piece.
Read more articles here:
http://www.shops-flower.com/itakeinfo/sa...
It's a miter saw, one where you hold the wood stationary while bringing the blade to the wood in a "Chopping" motion.
A radial saw attached to an arm that you pull down to saw wood and stuff in two
a chop saw has a circular saw blade and a deck , the saw has a handle and you bring the blade down to cut the wood . you can also adjust the blade for angled cuts. and miter cuts. they are normally called a miter saw http://www.northerntool.com/webapp/wcs/s...
here's a picture of one -- http://www.k9rdj.co.uk/mybuggy/saw1.jpg...
Its what the butcher uses to cut chops.
A chop saw is very similar in design to a miter saw, although they vary slightly. Chop saws typically have more power and different blade materials/styles to cut through more and heavier materials. The cuts tend to be less finished/accurate than a traditional miter saw and usually do not have the same amount of features for adjust angle cuts, etc.
Do the research to make sure it is the right tool for your project before buying one. A traditiona miter saw is usually better for most projects around the house, whereas a chop saw is used more often in an industrial/construction setting were a miter is also available.
I'm in commercial construction, we use a chop saw to cut metal studs. We have both and electric one and a gas powered one. They use grinding blades to cut through the metal.
The concrete guys use the same gas powered chop saw with a metal blade to cut through concrete.
There are many for wood,metal,plastic cutting.
Mitre saws that chop.
Compound mitre saws that cut mitre and mitred angle in one.
Radial arm that run on a rail over the work allowing to cut half way through for say half lap joints or tenons to be created.
Chop saw is like asking car? there are many for many uses.
If its diy then most stores will have some on display.
IF your looking for a specialist type of job then find a fellow who works in that field and ask him/her.
The type of saw with a blade that you have to keep your thumb well away from.
More Related Questions & Answers...