Whats a quickfix for gaps between floors and walls in a room?
Question:With the wear and tear of a home.I've noticed that there is a gap or space between my floor and the walls in my room.
I want to cover the gap up b/c i hate the look, and am terrified of creepy crawlies finding their way into my room that way.
What do you guys reccommend? BESIDES stuffing the gap with steel wool?
Can you guys break it down for me...with the specific names of products that I could purchase, and methods of closing the gaps.
Answers:
if you have flat walls or baseboards a quick and easy fix would be 1/4 round.
Check with your local hardware store. They will know & help u
you could caulk them with painters caulk non silicone or you could use 1/4 round it comes in various sizes measure the length of the wall cut the piece to length and nail it down
First, I want to say that you should get a building inspector to check your home. Normally, when your walls start separating from your floor, it has to do with your homes foundation shifting. It can cause a lot of real big issues. I recommend that you get it checked out by a professional. Secondly... if you decide not to, there are many fillers you can use. It mostly depends on the size of the gap. If it is only 1/4" to 1/2" you would be safe to caulk it. Just go to the hardware store, or even Wal-Mart, and they can point you in the right direction. If it is bigger than 1/2", then you need to get industrial Filler. You will have to go to Lowe's or Home Depot for something like that. Either way, the filler and the caulk both contain trail oils, which will show through after you paint it. I strongly recommend that you get it looked at. Good luck.
The proper fix would be the 1/4 round (small wooden piece) that sits at floor level outside of the baseboard. If it's present, it might need replacing if the house has settled. It's put on with small nails and can be gently pried off without damaging the baseboard. You will need to cut new pieces to fit.
As a female, I will also tell you that you can use caulk. If you are unfamiliar with it, it comes in a tube, and handles something like those cake frostings that you write with. It will seal the if the gap is not to large, and is easy to master.
Go to a hardware store where you can get someone to help you, get the caulk in the tube plus the caulk 'gun' (the metal holder that the tube fits in.) Cut the end of the tube as directed, at an angle, not to far down at first till you get the right amount to come out. Keep a couple of wet paper towels handy for your hands. Practice in a hidden area first. Follow direction on the caulk and draw a thin line with the caulk. Then run your finger along the line which will push the caulk into the gap and make a clean surface. You can wipe any extra caulk off the wall, floor, or your fingers with the wet paper towel. Allow the caulk to dry according to directions. If you want a good example of what caulk should look like, hopefully you can see a good job in the bathroom, like around the tub somewhere, or perhaps around some windows where the wood meets the wall.
Have no fear. You can do it. Good luck!
Sometimes when wall-to-wall carpeting is installed people will have the trim moved up a hair. If this is true use the 1/4 round trim at the bottom of the baseboard. You will need a miter-box saw and remember to reverse the angles when you saw. If you are not used to using this just take a piece of cardboard and keep shaving it until you have the right angle for that corner, then use it as a template for your cut.
If your house is old you could have a different issue. Older houses shift and settle. So much so that the original hardwood flooring will not be under the existing wall. The advice to have an inspector check out your structural integrity might be a good one. Assuming the gap is small and that you have hardwood floors you could have a new board cut to size and install it after removing the old piece. Be sure to get the same type and size wood.
More Related Questions & Answers...