Can I replace a washing machine motor coupling from underneath?
Question:It's a 12 yr. old Kenmore 90 series, and I can't get the cabinet off.
Answers:
i can't find my owners manual, i seem to remember that the top is popped by pushing in a clip on each corner in the front, from the front with a putty knife. now flip the top up, it's hinged at the back. then you remove the screws down each side in the back, and then the front and sides will come off. that will give you plenty of access to replace the coupler. you could try one of the many web sites that sells parts, some have directions too. good luck, sorry i couldn't find my manual for ya.
You should be able to access the motor from the back of the washing machine. Towards the bottom area should be a removable panel with approx 4 - 6 screws. Good Luck
I have had success tilting the washer and working from underneath, sort of like working under your car.But I'm not an expert,so, check out this site, hope it helps.
http://www.appliancerepair.net/cgi-bin/p...
yes you can and its very easy...all you have to do is lay machine on its back or side...the pump attaches to motor with three long screw.pull pump off shouldnt have to remove any hoses from pump...pull old coupling off and put new one on...reassemble..
I"M SURE YOU CAN
If you don't like long answers, don't continue reading.
1. Remove the two phillips screws on the front of the console ends. If you have end caps, pop them off to get to the screws.
2. Pull console slightly foreward and flip it back.
3. Unplug the lid switch harness and pop off the the two clips.
4. Pull the cabinet foreward from the top and lift it off.
5. Unplug the motor wiring harness and wires to the start cap.
6. Pop off the clips for the pump and motor. Support the motor when removing the clips. There will probably be 2-1/4 screws holding the motor clips, unless the coupling had been changed before.
Lift the motor off to see the coupling.
The ends of the new coupling should be flush with the motor and gearcase shaft's. You will need to tap them on with a hammer using a socket with extention.
Good luck, Once you'r done you'll see why Sears get's $170.00 to do it. Sears tech. 35 years.
More Related Questions & Answers...