Tap bit for 3/4 inch nut?
Question:want to drill and tap a size for 3/4 inch through a acrylic plate with a fitting for male pvc thread . thank you
Answers:
Not sure what this is for but acrylic does not drill or tap well. If this is a feed line for a tank or container that will be filled with water, I would suggest a Bulkhead fitting. It has a waterproof seal on one side and threaded fitting on the other. You drill a hole in the "wall" and insert the fitting and screw together. Makes a watertight connection and is less prone to cracking your plate.
Most PVC pipe use a standard pipe thread. You can usually find this at the hardware store, but watch out. Acrylic is very brittle and will crack easily.
Drill : 59/64
Tap : 3/4-14 NPS
More Related Questions & Answers...