I'm confused! Is the rotation of a circular saw typically counter-clockwise or clockwise?Can it be switched?
Question:
Answers:
There are saws with the blade on the left, and saws with the blade on the right. So they rotate clockwise if the blade is on the left and counterclockwise on the right. If the blade is on the left you put the blade on so the writing is hidden.
I don't think there are any saws that will let you switch directions. Occasionally, I turn the blade around (backwards) to cut something like vinyl siding.
Hope this helps
Clockwise, and no, you can't switch'em! Why in the world would you want to? I mean, all the blades are set to cut in one direction, they're not reversible.
The blade goes counter- clockwise & no it can't be switched. You can change the depth & the angle though.
The direction the saw rotates is not reversible, but fine-toothed blades can be reversed to get a smoother cut on lighter panelings or vinyl siding, etc. Check with your local lumber yard or home improvement store for what works best.
You could buy a reversible motor, but why?
If you've got a problem with putting on new blades, just stand in front of the machine and make sure the teeth are facing you when installing it.
The blade teeth point away from you as you are cutting. Not sure why you would want to reverse the motor direction as the blades will only cut in one direction unless you install the blade backwards. I have seen this done to cut thin metal but it is not a good idea. Better to get the proper blade.
Since there isn't a front or a back to a circular saw in the plane of the blade, terms like "clockwise" or "counterclockwise" are relative and not crystal clear.
A circular saw rotates so that the teeth at the front doing the cutting (vs. the teeth at the back that are just trailing) force the workpiece up, into the sole plate. If you reversed the motor, you would be pushing the workpiece away from the sole plate. Or more likely you would be pushing or launching the saw away from the workpiece ... a very dangerous thing to do.
When looking at the blade side of a circular saw the blade turns counter clock-wise. When looking at the blade side the teeth on the leading edge of the saw should be pointing up.
You can reverse the blade ( only do this with a fine tooth blade) to cut very thin wood, plastic or metal. If you do this be very, very careful and make sure you are using eye protection.
The motor itself can not be reversed.
The saw spins the way it spins for a reason, it draws the wood to the saw if you reverse it you would have to fight to hold the saw down. if dust is the problem, wear safety glasses. some saws even have dust collector ports on them that you can connect a bag or even pantyhose to to collect "most" of the dust..
More Related Questions & Answers...