My washing machine was foll of water when it had finished the cycle. What could be the problem?
Question:
Answers:
The water pump has failed to pump the water out during the rinse cycle. Before you call the repair man in, check if there is anything blocking the hose in the pump. Have a good day.
You need a new pump.
You my have waterbump problem.
Maybe there are socks stuck in the drain hose. Most likely is a broken pump, though.
The problem is nothing is built to last forever. time for new one.
there is a place on the washing machine it's either down on the left or on the right that needs cleaning just remove the plastic cover you will see a small plastic pipe inside there remove it's cover then the old stored water in the machine will come out through through it.take the instruction booklet if you have it to find this plastic pipe or just use my instructions.This have happen to me before.
Your outlet solenoid has not opened. Either the solenoid has died or something in the electrics has died and not told the solenoid to open. Either way it is an electrical problem and when playing with water and electricity leave it to the pros.
Pump. I had that same problem a few months ago. Cost me about $100 for a guy to put a used part in. If your washer is more than 5 years old, you are better off getting a new one.
See if the hose that drains the water out is pushed down far enough in the box in the wall. Push it down as far as it will go, then start the cycle again. This is a common cause, but it still could be something else. Doesn't hurt to try. Good luck.
your pump is probably out..
not sure but the part that spins u can check to make sure its still on the grooves that it connects too, that was wrong with mine before.
More Related Questions & Answers...