I am having a problem with my hoover 1200 washing machine, does everything except wash, any ideas.?
Question:
Answers:
Check pump,filter,sometimes if there is something preventing pump fins from turning it can even fail motor action,check there is water both hot and cold up to machine,possable module failure,is it a mechanical timer,is it rectified when you advance it.Or is it a digital timer,locate module and see if any component has blown or tracking. On newer machines modules can even break down if there is a fault with the interlock or pump
hi it sounds like your programme switch has gone . i hope this is some help to you . good luck
All hoover washing m/c are digital controlled now , you have a problem with the circuit board, they will come along and put a new one in, they call it electronics , when all it is, is undoing a set of screws and replacing the old part with one out of a packet.they are good at writing a large bill out though.
If it is working and it sounds as if it is, it sounds like the filter is blocked.
Do you mean the drum will not rotate if so sounds like the bearings are ko. If in warranty call Hoover if not sounds like you need a new machine
Bushes - call an engineer
If the machine is taking in water and emptying when it should but theres no movement from the drum then yes in the first instance i as an engineer would be looking at the carbon brushes on the motor,this isnt an expensive job,but i would recomend getting somebody qualified in to take care of any repairs.
If however there is drum movement but the program isnt advancing automatically after taking in water,meaning you have to turn the dial by hand,then chances are the heater element has gone,this would cause the programmer to stick at certain points because it cannot advance past the heating stage because the heater has packed in.Again this is not a major job,but should only be delt with by a compident engineer. hope this is of help
More Related Questions & Answers...